HOW TO USE HWT-1 DRY PELLET LUBE

---

HWT-1 is a dry film lubricant to out-perform any other pellet lube.  Friction is lowered and lead deposits from previously used pellets inside the barrel are reduced, leading to less fliers. In our experience, accuracy and consistency goes up by a good 15 – 20% when you use a dry lube. There  is enough in this 50ml bottle to lube at least 25 tins of pellets. Spray application or use the dropper supplied.
 

Here's how to use it:-
1.  Get a sealable sandwich bag, carefully put a couple of hundred pellets into the bag (so as not to damage them).
 

2.   In a ventilated space, spray 2 squirts, or with the dropper supplied, put 2 or 3 drops of HWT-1 into the sandwich  bag with your pellets, get rid of most of the air in the bag, seal the  bag,  then roll the pellets around gently in the bag so that they are  covered evenly with the HWT-1.  The pellets don't need to be soaking,  just covered.
 

3.  Carefully empty the pellets  out onto a non-pourous plate (we find a ceramic sandwich/dinner plate  works best) and let them dry for at least 2 or 3 hours or overnight.  If  the pellets are still wet after a few hours, you have used too much! (A  little goes a long way).
 

4.  For best results, clean  your barrel with a "Pull Through" such as Napier, then use the pellets  as normal. This allows the HWT-1 to coat the inside of the barrel as  well. Clean your barrel every 500 – 1000 pellets.  

If you are looking for some pellet recommendations, try JTS Dead Center.
 

WARNINGS: 
Do not use near naked flames.
Use in a well ventilated area.

Do not Swallow.
Do not inhale.

RECENT CUSTOMER REVIEW:  

This  pellet lube was recommended by a friend who shoots a lot, targets and  field.  I have tried napier lube before, too messy with no benefits. I  followed the instructions for this dry lube, cleaned my barrel and after about 2 mags my groups tightened up nicely, more than they did without  lube. At this point I was impressed enough to be sold on the pellet  lube, however over the chronograph was another bonus. I am using JSB  Exact 8.44gr and before using the HWT1 lube, I was achieving 775 fps  (11.26ft lbs).  Now with the dry lube on the pellets, it shot up by  14fps to 789fps (11.67ft lbs).  Gun is more accurate, a bit more  powerful & no sticky pellets, it's like they have a dry silky  coating on them.  I've got a tin of pellets pre-lubed ready for  shooting. I'm impressed, good recommendation, thank you.  (Andy P.   20/3/26)