Spend £10 for FREE UK 1st Class Postage ~ Worldwide Shipping Available
YOU ARE RESPONSIBLE
WHAT YOU NEED TO SEND
WHAT YOU NEED TO SEND
Is your HW100, HW101, HW110 or HW44 too low or too high on power? According to the Law, it is YOUR responsibility to ensure that your air gun is within legal power output limits. All of our services include removing the anti tamper (AT). This allows you to control the power output without having to send your gun to HC every time you have a power fluctuation, just to have them lock the Anti Tamper down again, taking away control of YOUR gun. We are authorised to service sub 12ft lb guns only.
WHAT YOU NEED TO SEND
WHAT YOU NEED TO SEND
WHAT YOU NEED TO SEND
For a full service, we won't need your stock, scope or silencer. (The stock is easily removed by just unscrewing the 2 securing bolts found underneath the stock.) We will also need a tin of your USUAL pellets - we will test & tune the power output using these pellets. If you then use lighter or heavier pellets, please note that this will effect the power output.
**DROP OFF IN PERSON BY APPOINTMENT ONLY**
SERVICING
HW100 & HW101
Any calibre, any age, any model
Air Cylinder Service
£20/£25
Original Weihrauch HW100 & HW100Tuning Titanium Cylinders only - this service covers end cap thread & valve seals only (the gauge/seal involves additional work +£5). Please note: when removing the ends from an original Weihrauch Air Cylinder, some cylinder ends are not easy to remove, & whilst every effort is taken to ensure that there are no marks or scratches in the surface, it CAN sometimes happen & we proceed on the basis that you accept this risk. Return Shipping £9
Anti Tamper Removal - Send us Your Hammer
£60
If you are confident in your ability to take the gun apart, send us the hammer assembly and we will remove the anti tamper, replace/upgrade the hammer spring & install our Pro-Fit Hammer Spring Guide and return the unit back to you to fit yourself. Once the A.T. has been removed, you will be able to change the power yourself at home using a 7mm Allen Key (supplied). You can remain within legal limits without having to send your gun away each time. Return Shipping is £9 via Special Delivery.
Anti Tamper Removal - Send Us The Back Block
£65
Send us the back block & we will remove the anti tamper, replace/upgrade the hammer spring & install our Pro-Fit Hammer Spring Guide and return the unit back to you to set the power up yourself (balance the hammer spring tension & regulator pressure. Once the A.T. has been removed, you will be able to change the power yourself at home using a 7mm Allen Key (supplied). You can remain within legal limits without having to send your gun away each time. Return Shipping is £9 via Special Delivery.
Full Service
£125
What we do: Complete strip-down, de-grease, replace all orings, clean the barrel, remove AT (if it hasn't already been done), replace hammer & valve springs, polish the hammer, service the regulator, replace regulator springs, tune power output (12ft lb maximum), airtight test & a chrono report. Please include a tin of your usual pellets for us to test and set up with, we return what we don't use. This takes 7-10 days. Return shipping via *ParcelForce is £15 or Special Delivery £28.
Full Service & Upgrade
£165
What we do: Everything in the Full Service above PLUS these upgrades: Pro-Fit Hammer (not suitable for MK1), Regulator Belleville Guide, hammer & valve springs, ©Regulator Test Port Seal, Fast Flow Exhaust Valve (if required, not all guns benefit from this), ©Valve Protection Spacer. Please include a FULL tin of your usual pellets for us to test and set up with, we return what we don't use. This takes 7-10 days. Return shipping via *ParcelForce is £15 or Special Delivery £28.
Full Service, Upgrade, Fit & Fine Tune The HWT 250bar Titanium Cylinder
£185
This service is for anyone purchasing our HWT 250bar Titanium Cylinder and would like us to fit and fine-tune for optimum shot count & consistency.
What we do: Everything in the Full Service & Upgrades above, PLUS install the HWT 250bar Titanium Cylinder. Please include a tin of your usual pellets for us to test & set up with, we return what we don't use. This price is for the service only - it does not include the cylinder. Return shipping via *ParcelForce is £17 or Special Delivery £28.
+ New Style Biathlon Lever
£48
ADD ON TO SERVICE: Whilst we have your gun for a service, we can swap the plain cocking lever for the new style Weihrauch Biathlon Lever (& return your old cocking lever to you).
HW110 & HW44
It's common for the HW110 to suffer from power loss, ONE of the causes - the hammer spring & anti tamper. You cannot get access to the hammer spring, it has to be done with specialist tools. We can remove the anti tamper and replace the hammer spring with a pre-tensioned spring. It WILL wear in a bit with use (as all springs do) but not as much as the Weihrauch spring, and because the AT has been removed, you will be able to adjust the power yourself if you need to.
Anti Tamper Removal - Send us Your Hammer Assembly
£60
If you are confident in your ability to take the gun apart, send us the steel striker/shuttle assembly and we will remove the anti tamper, replace/upgrade the hammer spring and return the unit back to you to fit yourself. Once the AT has been removed, you will be able to change the power yourself at home very easily using our step by step guide. This enables you to remain within the legal limit without having to send your gun away each time. Return Shipping is £9 via Special Delivery
Anti Tamper Removal - Send us Your Gun
£65
If you are NOT confident in your ability to take the gun apart, send us the gun and we will remove the anti tamper, replace/upgrade the hammer spring, set up the power to approx 11.5ft lb (HW110) or 5.8ft lb (HW44) and return the gun to you. Again, the AT is removed to enable you to remain within the legal limit without having to send your gun away each time. This does NOT include a service. Return Shipping is from £15 via Parcel Force or Special Delivery £28.
Service & Anti Tamper Removal
£125
If you are not confident in your ability to take the gun apart, send the gun to us and we will carry out a service & remove the anti tamper & replace/upgrade the hammer spring. Once the AT has been removed, you will be able to change the power yourself at home very easily using our step by step guide. This enables you to remain within the legal limit without having to send your gun away each time. This takes 7-10 days. Return Shipping is £15 via *ParcelForce or Special Delivery £28.
+ HW110/HW44 Mag Lever Or Cocking Lever Moving to the Left
£5
Having the cocking lever AND the magazine lever on the same side is a bit of a hand full. Whilst we are carrying out the Full Service, if you would like us to swap over either the Magazine Lever or Cocking Lever from the right to the left hand side, just let us know.
+ HW110/HW44 BLACK Mag Lever Or Safety Lever
£60
MK1 HW110 has silver Magazine Lever and Safety Lever - whilst we are carrying out a Full Service, if you would like us to swap over the silver parts for black replacements, we can. (We will return the silver parts to you). When replacing these parts, we can also move either the Magazine Lever or Cocking Lever from the right to the left hand side of your rifle - helpful for left handed shooters, just let us know when you book your rifle in which side you prefer.
+ HW110/HW44 Air Cylinder (gauge end) Service
£10
One of the problems with the Weihrauch Air Cylinder is that a lot of people dont put lubricant onto the fill probe - this can lead to dry bits of rubber shearing off the fill probe and getting stuck in the fill valve - this can lead to leaking and/or filling problems. It is recommended that you add this option to your HW110 Service - we will clean out the fill valve & re-seal it to ensure you can start filling your air cylinder with a clean valve.
+ HW110 Titanium Air Tube - Lighter & MORE Shots
£140 / £150
When sending your HW110 to us, why not have a lightweight, titanium Air Tube at the same time? Our Extended Ti Air Tubes are 45mm longer than the original air tube, but don't interfere with the moderator. We will remove the ends from your original cylinder and fit them to one of our ti tubes (we will return your original). Lightweight, more balanced, better looking & more shots!
Carbine = 259g + approx 30 extra shots per 200bar fill
Rifle = 436g + approx 20 extra shots per 200bar fill
By booking a service with us, it is assumed that you agree to our terms, conditions & exceptions.
Click the button below to see a guide on how to adjust the power on your HW110 once the Anti Tamper (AT) has been removed
Posting your Gun
Please always ensure that any air cylinder that you post is completely drained of air.
Royal Mail/Post Office will accept parcels with low powered (12ftlb or under) air guns / parts over the counter as long as the parcel is no more than 61cm long (Medium Parcel). You can use whichever service you prefer with as much compensation as you require (special delivery is next day delivery with enhanced compensation - ie. with £1,000 cover & next day delivery is £16 from 1st April 2022).
If the parcel is longer than 61cm, then it is classed as a “large” parcel and will have to go via *Parcel Force, subject to the following conditions:-
• It has to be sent on 48H, as this is not flown anywhere.
• Compensation only available for delay.
• Compensation will be prohibited for loss or damage
• Customers cannot purchase enhanced compensation
• If PO sends an air weapon on express24, it is not eligible for compensation
Please make sure that you enclose a note in the parcel with your contact details on.
Please also put your name and return addres son the outside of the parcel - this helps us to identify the parcel & let you know that it has arrived.
Parcelforce will not be providing a 15% discount code from April 2022 as they are reducing their prices instead.
Drop off & collection in person is by appointment ONLY. Tuesday to Friday after 10am, Saturdays after 11am.
When posting your parts/gun to us, we would recommend that you use plenty of bubblewrap & a sturdy cardboard box. Give the box a shake, if you can hear anything moving about, you need more packing material inside the box to secure it - scrunched up newspaper, towels - we have even received parcels packed with teddybears, jumpers and socks! No, we won't do your laundry if you send it :-) We cannot be held responsible for guns arriving damaged due to poor packaging. When sending pellets, please ensure that the lid is sealed so they do not come loose during transit.
WHAT DO I NEED TO DO NEXT?
Additional Information
For a Full Service or Service & Upgrade, we wouldn't need your scope, stock, magazine or silencer unless your silencer is bonded on or it’s on a custom fit barrel (we have plenty of standard silencers). If you prefer to leave the stock on, that's no problem.
For the HW100 & HW110 - we will need your block/trigger unit, barrel & air cylinder.
For the HW44 - we will need the entire gun + the moderator.
We will also need a tin of your usual pellets to test and set up the power output with – anything we don’t use we will return. We will need a tin of the pellets that you use REGULARLY - this enables us to fine tune the power output of your HW100 to ensure that it remains within the UK legal limit. Please bear in mind when providing pellets that the grains (weight) effects the power, eg. if you supply us with 13.43gr pellets, we will set the power output using these pellets. If you then use lighter pellets (eg. 8.44gr) you will experience a reduction in power. If you use heavier pellets, the power will increase. The pellets need to be clean, free from lubricant and it helps if it is a new, unused tin - if you send a tin of mixed weight/make pellets that you scraped out of the drawer, we cannot set the power output properly as different weight pellets will give different results.
Once the work is done & it is power tuned and airtight tested - we will send a secure link to an invoice, it can be paid by debit or credit card, paypal or bank transfer, whichever is easier for you.
Make sure you get everything wrapped up well in a sturdy box, bubblewrap or sponge are best for packaging, but we have had parts arrive wrapped in towels, jumpers, even socks! Make sure that the tin of pellets is sealed with tape so that it doesn't come open in transit, also pop a note in the parcel with your contact details on so that we know whose gun it is - please also mention which service(s) you require. Give the box a shake, if you can hear anything moving around, stuff some more packaging in there - even if it's just scrunched up newspaper.
If you (or anyone else) have attempted any work on the gun recently, changed any seals etc.. it's always handy to know. If there are any problems with the gun ie. it's leaking (fast or slow), power has dropped or increased, power goes up and down, please also let us know.
If you would like to get it booked in, let us know when you are ready and we will forward shipping details.
This website uses cookies.
We use cookies to analyze website traffic and optimize your website experience. By accepting our use of cookies, your data will be aggregated with all other user data. Privacy Policy